Direct View LED DisplaySupport - ViewSonic United Kingdom

What are the power source requirement for DVLED?

Power Receptacle Type L5-30P, EU, UK, AU, CN (may vary depending on region. double check power supply compatibility) Power Input Voltage Range 100-240 V ~ 50/60Hz Input Current 30A max @110V; 15A max@220V Leakage Current <0.25mA@240VAC Power Outlet quantity 1 (for 108", 135", 163"), 2 (for 216") *Recommended use on a singl...

What should I do if the LED(s) on the DVLED display is unlit?

Answer: Please refer to the LED dead pixel specification in the User Manual to determine if it needs replacing, or contact the local service provider for proper assessment. Click each model to view detailed replacement specificationsDeactivated pixels determination for LED module replacement based on Acceptance Criteria for 1) whole dis...

What is the Cabinet installation order of the DVLED Floor Stand configuration?

The Cabinet installation order varies from the Wall-mount configuration. Please follow the steps in the respective order for the Floor Stand configuration: Cabinet B moved to the left side of the floor stand bracket Ensured rear-cabinet mounting bracket is securely placed onto the top cross beam of the floor stand Ensured notches under the ...

What is the LED Module installation order of the DVLED Displays?

The LED Module installation order is the same for the Wall-mount and Floor Stand configuration. Please follow the steps in the respective order for the LED module installation order: Anti-static gloves worn Began handling with delicacy, following numbers marked on the box of each module Confirmed arrow facing upwards when installing the LE...

How do I remove LED Modules from the DVLED Display?

Solution Step 1: Wear anti-static gloves before handling the LED Modules. Step 2: Remove the Vacuum Suction Tool from the box and press its power switch to use it. Please charge it with the included power supply and make sure the vacuum suction tool is kept in a fully charged state. Step 3: Move the Vacuum Suction Tool to t...

Why is an entire column of LED Modules not on even though my DVLED Display is powered on?

DVLED Display with an entire column of unlit LED Modules. Answer: There may be poor connection or loose wiring with the connectors from the System Control Box to the LED Module adapter board. Solution The column's most bottom LED Module will need to be removed with the Vacuum Suction Tool in order to access the connectors. ...

What's causing the LED Modules to raise on top of each other (not flat) on my DVLED Display?

After LED Module installation, if there are steps (not an even display surface), it could be a number of reasons: Debris in the magnetic mating surfaces (both on the LED Module and Cabinet) Locking Bolts were not engaged Locking Bolts were not aligned before engaging Affected tile(s) are not aligned and installed as evenly as possible. Thi...

I received 2 power cords for my 216" DVLED Display, does it require both?

Answer: Yes, the 216" DVLED Display requires 2 power cords (differs from the standard requirement). Each power cord produces 3300W. The power a 216" Display produces is greater than 3300W.

What is a "hard calibration" for DVLED Displays?

Answer: "Hard calibration" is a form of hardware calibration that fine tunes the color and brightness for specific LED modules on the DVLED Display. Situations in which hard calibration may be required: LED Module position is changed or LED Module is replaced with a spare, LED Modules from a different color batch need to be used, LED M...

What is a Transfer Board on a DVLED Display?

The Transfer Board (also known as a Transfer Card) is an internal component that facilitates signal connections between LED modules and the cabinet. Note: Current models have largely transitioned to "3-in-1 Boards." This article is for legacy product maintenance and technical reference only. Key Functions: Signal Supplementing: Routes ...