LED MonitorSupport - ViewSonic United Kingdom

What to do when there is touch inaccuracy of the TD monitor under Windows 10?

Please do touch calibrate follow below steps: 1. Move your mouse cursor to the bottom left of the screen. Right mouse click the Windows icon, then left mouse click “Run”. 2. Key in or copy: shell:::{80F3F1D5-FECA-45F3-BC32-752C152E456E} and select "OK". 3. The Tablet PC Settings will show up as below. You can select TD m...

How to enable AMD FreeSync?

LED monitors produced after 2020 have FreeSync enabled by default. For LED monitors manufactured before 2020, please refer to the following instructions to enable FreeSync. To use AMD Freesync, there're some requirement with graphics cards, graphics drivers and certified monitors. 1. A compatible GPU with a DisplayPort connection. ...

What ViewSonic monitors support GeForce Driver G-Sync Enable-Ready?

ViewSonic FreeSync monitors support GeForce Driver G-Sync Enable-Ready. *Legal Disclaimer for GeForce Driver G-Sync Enable-Ready: Our product follows the Adaptive Sync technology standard adopted by the Video Electronics Standards Association (“VESA”). Our product is compatible with and certified by AMD for AMD’s FreeSync Te...

How to output video at 120 Hz from PS5 or Xbox Series X/S to ViewSonic monitors.

PlayStation 5 and Xbox Series X/S consoles support video output up to 120 Hz. Follow the instructions below to configure 120 Hz output. <PlayStation 5> 1. Open "Settings". 2. Select "Screen and Video". 3. Select "Enable 120 Hz Output" under "Video Output". 4. Select "Automatic" in the pop-up menu. 5. Return...

What is "Black stabilization" and which level should I choose?

This setting is to provide better picture performance if user’s screen are mostly dark scenes. If no special needs(ex: playing shooting games in dark scenes), it is suggested to turn off.

Why can't I choose Contrast or Brightness?

Certain preset modes (ViewMode) are factory-calibrated for specific visual tasks and will lock parameters to maintain optimal performance. Switch to [Standard] mode to regain manual control. Step-by-Step Instructions: Press the [Menu] button (located on the back or bottom of the monitor) to open the OSD menu. Navigate to the [ViewMode...

What should I do if vertical or horizontal lines appear on my monitor?

Identify whether it is a "Hardware Failure" or a "Signal Issue." The quickest way is to open the monitor's OSD menu to isolate the cause. Perform the OSD Test (Crucial): Press the monitor buttons to bring up the built-in menu. Lines appear OVER the menu: This indicates a hardware/panel failure. Proceed to step 5. Lines are NOT on t...

Which cable do I need to support a 144Hz refresh rate?

To achieve 144Hz, you must use the correct version of DisplayPort (DP) or HDMI based on your resolution. DP is the recommended interface for high refresh rates. Cable Requirement Table: Target Resolution Recommended Cable (or higher) Note 1080p (FHD) DisplayPort / HDMI 1.3 Supported by most modern cables 1440p (2K) DisplayPort 1.2 /...

Why can’t my monitor automatically detect a source?

The "Auto Detect" feature is disabled by default on many models. You must manually enable it within the OSD menu to allow the monitor to switch between active ports automatically. Step-by-Step Instructions: Press the physical button to call up the OSD Main Menu. Navigate to the [Input Select] section. Locate [Auto Detect] at the bo...

How to Install Unsigned Drivers in Windows 10

When installing unsigned drivers on Windows 10, Windows pops up a warning saying Windows can’t verify the publisher of this driver software. The following are instructions on how to install unsigned drivers in Windows 10. NOTE: Checking driver signatures is a security feature in Windows, and disabling it is not rec...