Parts can be purchased from our parts store. Go to https://www.viewsonic.com/parts/
Please refer to user guide on page "Important Safety Instructions". Some projectors may be claimed to use at a limited angle dependent on the light source, such as lamp or LED.
Please refer to this FAQ.
Make sure that you have set it to its native resolution. Check the user guide to determine what the native resolution of the display is and set it to the native resolution if the video source that is being used can support it. Digital signals (HDMI, DisplayPort) normally produce sharper images. If you are using a VGA or analog signal try to s...
1.Please increase the Contrast and Brightness in OSD menu. 2.Check the light source level and make sure it’s on Full or Normal. 3.Turn off or reduce environmental luminance where the projector is in use.
Stuck or twinkling pixels on the projected image may be due to a defective DMD chip. These pixels can show up as bright, dark or twinkling points. They look similar to pixel defects on LCD displays. This cannot be fixed by the end user and must be sent in for service. Contact ViewSonic Customer Care to verify if your unit qualifies for warrant...
To locate the maximum or native resolution for a projector, there are a few places this can be found. We highly recommend using the native resolution for LCD displays as this will provide the clearest possible image from the device. Check the product page for your model on the Viewsonic website and you will see the native resolution displaye...
Windows update may cause some issues with screen resolution setting being lost, Please follow below steps to change the resolution of the screen and check: Type Change screen resolution in the Search box from the desktop and click Change screen resolution of the display. Under Display Resolution select Recommended resolution. A wi...
When a digital signal is connected (e.g. HDMI, DisplayPort, DVI), there are certain options greyed out in OSD menu as preset settings that cannot be changed. Those greyed out settings will be available when an analog signal (e.g. VGA) is connected.
1.If spot is only visible when projected image in defocus, it would not impact usage. 2.If spot is visible when projected image in focus, please contact ViewSonic Service center for help.