How to do Crestron E-control workaround due to Adobe Flash player not being supported?

Step 1  Download and install a Flash Player. “Download the Flash Player projector” from Adobe: https://www.adobe.com/support/flashplayer/debug_downloads.html Step 2 Input the URL of the Crestron interface in the Flash Player: http://[projector.ip]/CrestronUI.swf Where [projector.ip] is the ViewSonic projector’s IP address.

What are the formats and maximum size do the USB and MicroSD reader on the LED projector support?

Please see the table below: Supported Size (Max. Size) NTFS Format FAT32 Format Read Write Read Write USB Memory Stick 256 GB V N/A V V USB HDD 2 TB V N/A V V Micro SD 256 GB V N/A V V Note: 1. Windows 10 built-in format tool only supports FAT32 format up to 32 GB. 2. Firmware upgrade only supports FAT32 format.

What to do if the image is too dim from the projector?

1.Please increase the Contrast and Brightness in OSD menu.   2.Check the light source level and make sure it’s on Full or Normal.   3.Turn off or reduce environmental luminance where the projector is in use.

What to do if the image shows keystone effect from the projector?

When you see below situation, please follow below instructions to adjust:   If the projector supports Auto Keystone or Vertical keystone, please try to turn on or manually adjust by referring to user guide. If possible, put the projector on the flat surface and make sure projector lens and screen are in a 90-degree angle.  

How to Install an All-in-One Interactive Projector like PS750W

Please refer to the video in YouTube as below link. https://www.youtube.com/watch?v=OPZ-25Q-BAk

How to mirror an iPad or an iPhone screen to a projector?

There are 2 ways to mirror from iPad, iPhone (4 or later), or iPod Touch (4th Gen or later):   1. Use an Apple original "Lightning Digital AV Adapter" or "USB-C Digital AV Multiport Adapter" to connect your device to a ViewSonic projector. You might encounter no signal if you don’t use APPLE original adapter.   2.If your projector is equipp...

How do I connect external speaker(s) to my projector?

1.Wired connection:   1.1 via 3.5mm audio out:       If the projector is equipped with a 3.5 mm audio out mini jack, usually it is  green and marked as          Audio Out. Please connect a 3.5 mm audio cable between speaker and projector for audio output        purpose.     1.2 via S/PDIF:        If the model is equipped with S/PDIF por...

How to restore the default settings on a projector?

1. Press the menu button on the projector or the remote control and then navigate to the Advanced Settings.   2. Select to restore factory default settings.   Note: Some models may have the reset option in a slightly different location. Please check the user guide for specific steps.

What to do if there is spot on the projected image?

1.If spot is only visible when projected image in defocus, it would not impact usage.   2.If spot is visible when projected image in focus, please contact ViewSonic Service center for help.

What to do if remote control does not work properly?

  Please do the following check: Make sure there are no obstructions in the way of the IR receiver on the device. Move closer to the receiver (within 23 feet) or change the angle (within 30 degrees) to the receiver. Replace the batteries. Even if lights on the remote control are on, weak batteries may still cause the remote control to oper...