LED Monitorการซัพพอร์ต

How to restore the monitor to factory default settings?

Use the "Memory Recall" or "All Reset" option within the monitor's OSD menu to revert all adjustments to their original state. Open the OSD Main Menu: Front Buttons: Press the button labeled [1] or [Menu]. Rear/Side Buttons: Press the designated menu button (refer to the icons on the bezel). Joystick Control: Press the center of...

Why is there touch response randomly on my TD2220/TD2421 even nobody touches the screen?

These models are optical touch monitors which use two CMOS cameras (optical sensors) placed in the corners at the top of the screen as well as three reflectors (light strips). These cameras are used to look across the entire touch surface for touch events. When an object touches the screen, it blocks some of the light being received by the se...

How to do color calibration with my monitor?

Please refer to this FAQ, find "Calibrate your display" section and follow the instruction.

Why is my monitor emitting a high-pitched noise or buzzing sound?

Slight electronic humming is often normal (Coil Whine); however, persistent or loud noise may require environmental troubleshooting or technical support. Check Power Source: Plug the monitor directly into a wall outlet instead of a power strip to rule out electrical interference from other devices. Adjust Brightness: Try changing the b...

How to clean LCD display?

General Precautions Make sure the monitor is turned off and the power cable is unplugged from the power outlet. Never spray or pour any liquid directly onto the screen or case. Doing so could damage your monitor. Dust or hard materials may scratch the screen. Please make sure the cleaning cloth is free of any debris. Clean and dry the m...

How to solve the overscan problem with my monitor?

If the image does not fill the screen of the monitor or if it looks like the image is slightly too big for the monitor, try below suggestion. 1.Adjust setting on the PC/laptop: (1)Set native resolution of monitor in your PC/laptop's Display settings. (2)Change Scaling in Display settings. Use the graphic card software to change ...

How to setup and configure dual monitors?

Connect your cables, then use system shortcuts to choose between "Extend" or "Duplicate" modes and arrange the display order. Step-by-Step Instructions: 1. Fast Mode Switching (Windows) Press the Win + P shortcut. Select [Extend] to use both screens for different content (Recommended). Select [Duplicate] to show the same image on b...

Where to download ViewSonic monitor drivers for Win7 64-bits?

Please download the attachment and manually install the drivers under Win7 x64. File URL:https://support.viewsonic.com/helpdesk/attachments/33058629684

Why Your Monitor Mount Joint Might Be Stiff

The rotation axis of the Arm Hinge may feel tight or exhibit restricted movement. This is by design, as the axis incorporates a degree of resistance to help prevent the monitor from dropping, tilting, or moving unintentionally after installation. Before a monitor is installed or when the monitor’s weight is not applied, the rotation...

Which cable do I need to support a 144Hz refresh rate?

To achieve 144Hz, you must use the correct version of DisplayPort (DP) or HDMI based on your resolution. DP is the recommended interface for high refresh rates. Cable Requirement Table: Target Resolution Recommended Cable (or higher) Note 1080p (FHD) DisplayPort / HDMI 1.3 Supported by most modern cables 1440p (2K) DisplayPort 1.2 /...