ProjectorSuport - ViewSonic Romania

How to mirror iPhone or iPad screen to the projector? (Wired Connection Guide)

Use a USB-C cable or an appropriate HDMI adapter for a stable, low-latency wired connection. USB-C Direct Connection (Recommended): Use a USB-C cable that supports video transmission (using the cable provided with the projector is highly recommended). Connect your device directly to the projector's [USB-C] port. Select [USB-C] a...

How to fix the keystone effect (distorted image) on a projector?

Ensure the projector is level and perpendicular to the screen, then use the built-in "Keystone" settings to square the image. When you see below situation, please follow below instructions to adjust: Physical Alignment: Place the projector on a flat surface. Ensure the lens is at a 90-degree angle relative to the center of...

How to play 3D content from Blu-Ray player to projectors?

1. Here are the hardware requirements to play 3D content below. a. 3D ready projector b. 3D Blu-Ray player c. 3D content d. Active 3D glasses 144Hz e. HDMI Premium Certificate cable 2. Here is the playback process below. a. Connect the 3D Blu-Ray player to the 3D capable projector via HDMI cable. b. T...

Want to know about supported picture, video and audio formats

Each product has its own list of compatible video, audio and image formats. The best way to know what file type is specifically supported by your product is to look in the user guide for your particular model.

Can I change the orientation of the projector when in use?

Please refer to user guide on page "Important Safety Instructions". Some projectors may be claimed to use at a limited angle dependent on the light source, such as lamp or LED.

What to do if the image is too dim from the projector?

1.Please increase the Contrast and Brightness in OSD menu. 2.Check the light source level and make sure it’s on Full or Normal. 3.Turn off or reduce environmental luminance where the projector is in use.

How to change the projector lamp in a projector?

The methods for changing the projector lamp (bulb) differ depending on the model of the projector. For accurate instructions, you can find lamp swapping instruction at ViewSonic product download page. <Note> It is recommended that you use an authentic ViewSonic replacement lamp.

There is a pixel stuck on or off

Stuck or twinkling pixels on the projected image may be due to a defective DMD chip. These pixels can show up as bright, dark or twinkling points. They look similar to pixel defects on LCD displays. This cannot be fixed by the end user and must be sent in for service. Contact ViewSonic Customer Care to verify if your unit qualifies for warrant...

The image is out of focus

Make sure that you have set it to its native resolution. Check the user guide to determine what the native resolution of the display is and set it to the native resolution if the video source that is being used can support it. Digital signals (HDMI, DisplayPort) normally produce sharper images. If you are using a VGA or analog signal try to s...

How to adjust the image size on a projector?

Adjust the image size by changing the "Throw Distance," rotating the "Zoom Ring," or using the "Digital Zoom" setting in the menu. Adjust Throw Distance (Physical): This is the most effective method. Move the projector further from the screen for a larger image, and closer for a smaller one. Use the Zoom Ring (Optical): Rotate t...