Please connect the projector to a different AC outlet. Connect the projector to another computer/player. In case above crosscheck remains the same result, please contact ViewSonic service center.
Analog extension cables, adapters, docking stations and longer cables may be prone to generate ghosting, lines, double images, or poor focus. The improper shielding of the extension cables will cause a shadowing or ghosting effect due to mismatch of the input impedance between the video source, the video cable, and the projector. Please use th...
1.Wired connection: 1.1 via 3.5mm audio out: If the projector is equipped with a 3.5 mm audio out mini jack, usually it is green and marked as Audio Out. Please connect a 3.5 mm audio cable between speaker and projector for audio output purpose. 1.2 via S/PDIF: If the model is equipped with S/PDIF por...
1. Press the menu button on the projector or the remote control and then navigate to the Advanced Settings. 2. Select to restore factory default settings. Note: Some models may have the reset option in a slightly different location. Please check the user guide for specific steps.
There are some possible reasons caused, please check below first: <Airflow> Air Flow is important for cooling: Please make sure the intake and exhaust vents are free from obstruction. Make sure the projector is not enclosed or right against a wall - it needs ventilation space. Don’t place the projector on top of other electr...
1.If spot is only visible when projected image in defocus, it would not impact usage. 2.If spot is visible when projected image in focus, please contact ViewSonic Service center for help.
Please do the following check: Make sure there are no obstructions in the way of the IR receiver on the device. Move closer to the receiver (within 23 feet) or change the angle (within 30 degrees) to the receiver. Replace the batteries. Even if lights on the remote control are on, weak batteries may still cause the remote control to oper...
For Models: PA/PG/PX Series “Power On” and “Power Off” are separated as two (2) different buttons on the remote control. This is different from the PJD series.
If the external monitor/ projector is not automatically detected and displaying an image, you will need to use a function key to enable or activate the function. Laptop manufacturers have different methods to activate an external monitor. Refer to the laptop's user guide/manual or the manufacturer for instructions to activate the video port for...
Stuck or twinkling pixels on the projected image may be due to a defective DMD chip. These pixels can show up as bright, dark or twinkling points. They look similar to pixel defects on LCD displays. This cannot be fixed by the end user and must be sent in for service. Contact ViewSonic Customer Care to verify if your unit qualifies for warrant...