VG2448 doesn’t support Auto Pivot Function but integrated with below features instead. 1. VG2448 supports +/- 90 degree pivot, and users need to do manual adjust for screen rotate or OSD rotation. 2. There's "OSD pivot" option in OSD menu l VG OSD tree
If you see a crosshair in the middle of your VX3258-2KC-MHD monitor’s screen, please perform the step below. With the monitor powered on, press the joy key downward on the back of the monitor to toggle the crosshair on or off. To bring it back up press downward on the joy key again.
Input lag means the time difference between when user controls PC and sees the response on monitor. There is a trade-off to picture/video performance. If no particular demand, it is suggested to set it to off.
If you run into the templates not being centered properly, please follow the below steps: 1. Right click on the desktop icon of ViewSplit and Select “Properties”. 2.When the properties window pops up select the tab “Compatibility”. 3. Select “Change high DPI settings”. 4.Check the “Program DPI” box and the drop down “I op...
Your ViewSonic monitor must be set to the Main display. To verify this please follow the steps below: 1. Right click on your desktop and select “Display Settings”. 2. Click on the display number at the top that you want to make the main display and check the “Make this my main display box” under Multiple displays. 3. If th...
ViewSonic XG2401/XG2402/XG2701/XG3202-C can support the resolution 1920x1080@144Hz in HDMI. However, to enable 1920x1080@144Hz, there'll be some requirements except for the monitor. 1. Graphics card/Laptop: Must support HDMI 1.4 output with 340MHz pixel clock or HDMI 2.0 output capability. 2. HDMI cable: It's suggested to connect...
This is an indicator about power consumption ratio which is affected by some OSD settings change, ex. ECO mode and Brightness. Here's a matrix table about ECO mode and power consumption ratio. ECO mode Power consumption ratio Standard 100% Optimize 85% Conserve 70%
1. Connect the USB cable to the monitors USB Type B port on the back of the monitor and attach the other end of the cable to an available USB port on the computer. Allow 10-15 seconds for the computer to recognize the external webcam. Please do remember to connect the video signal cable between monitor and computer. NOTE: This method will ...
When resolution is set in native resolution (1:1), both Sharpness and Overscan option in OSD will be grey out.
You can refer to this video. 1. Lay the monitor unit face down on a flat surface, using the soft bag received or a soft material to avoid damaging the screen. 2. Insert and align the Neck of the stand (Do NOT attach the base to the neck) into the stand slot on the display. 3. Firmly push the neck into the slot while securing t...