For Models: PA/PG/PX Series “Power On” and “Power Off” are separated as two (2) different buttons on the remote control. This is different from the PJD series.
If the external monitor/ projector is not automatically detected and displaying an image, you will need to use a function key to enable or activate the function. Laptop manufacturers have different methods to activate an external monitor. Refer to the laptop's user guide/manual or the manufacturer for instructions to activate the video port for...
Stuck or twinkling pixels on the projected image may be due to a defective DMD chip. These pixels can show up as bright, dark or twinkling points. They look similar to pixel defects on LCD displays. This cannot be fixed by the end user and must be sent in for service. Contact ViewSonic Customer Care to verify if your unit qualifies for warrant...
Each product has its own list of compatible video, audio and image formats. The best way to know what file type is specifically supported by your product is to look in the user guide for your particular model.
Parts can be purchased from our parts store. Go to https://www.viewsonic.com/parts/
To locate the maximum or native resolution for a projector, there are a few places this can be found. We highly recommend using the native resolution for LCD displays as this will provide the clearest possible image from the device. Check the product page for your model on the Viewsonic website and you will see the native resolution displaye...
Make sure that you have set it to its native resolution. Check the user guide to determine what the native resolution of the display is and set it to the native resolution if the video source that is being used can support it. Digital signals (HDMI, DisplayPort) normally produce sharper images. If you are using a VGA or analog signal try to s...
If you are experiencing problems using HDMI input: Confirm the HDMI input is selected. Plug in the projector first, and then turn on the PC. Replace the HDMI cable, sometimes a cable may go bad. Try another signal type if available for example: VGA, DVI, DisplayPort. Test the projector on a different computer with a HDMI port to make sure...
Verify adapter plugged into a wall outlet Make sure the AC adapter is firmly and securely plugged into the wall outlet. Although it may sound obvious, the adapter can become loose without even knowing. If it's not plugged in all the way, it can make it seem like the adapter is not working, but it may just not be getting power from the wall...
To clean the projector lens, do the following: Apply a non-abrasive camera lens cleaner to a soft, lint-free cloth. Do NOT spray the cleaner directly onto the lens. Avoid abrasive cleaners/solvent, as they may permanently damage the lens. In a circular motion gently wipe the lens clean. Replace lens cap if projector is not to be used.