Answer: Users can enter the setting screen from the main menu, select Date & Time under System, and select the correct time zone to complete the time zone setting.
Solution Please refer to the following diagram below. This information can also be found in each Direct View LED Display's respective User Guide. Recommended Links "Why is the DVLED Display remote control having trouble with sensitivity or not working?" "How do I lock the remote control for my DVLED Display?"
Power Receptacle Type L5-30P, EU, UK, AU, CN (may vary depending on region. double check power supply compatibility) Power Input Voltage Range 100-240 V ~ 50/60Hz Input Current 30A max @110V; 15A max@220V Leakage Current <0.25mA@240VAC Power Outlet quantity 1 (for 108", 135", 163"), 2 (for 216") *Recommended use on a singl...
Answer: You can set the entry screen after the display is turned on. From the main menu go to Display settings then Startup & Shutdown. Choose whether to continue the input source from last shutdown, or to specify a specific source (Home, HDMI, myViewBoard Display, or vCast).
Solution This may be an issue related to the settings. Please check the RS232 settings when you encounter this issue: Also, check the RS232 pin definition: Note: RS232 does not need crossover If the user cannot use RS232 or Crestron to remotely turn on the power, refer: "Why can't RS232 be used to Power on/off the dv...
Answer: The Customer Maintenance Notice is a document that should be explained to the customer on-site, immediately after dvLED installation (during or after software setup). The document contains crucial information regarding proper usage and maintenance critical to effectively extending the life cycle of the product. Note: Full documen...
Yes. Please make sure you follow the below steps. Turn off Wireless hotspot on LDM/LDC. (Settings --> Network --> Wireless hotspot --> Disable) Use Mouse to select the display in vCast under Display group settings --> Device list
Answer: The Receiving Card (aka Receiving Board) plays a part in supplementing LED Module signal connection. It is directly connected to the Transfer Board as shown in Diagram 1 below. Diagram 1: Receiving Card mounted onto Transfer Card Signal is taken from the Transfer Board and sent to the Receiving Card, thus distributing th...
Solution When the display is operating, the current is transmitted in three ways: 1) From the “Power Board for Audio Board” to the “Audio Board” 2) From the “Power Board for Main Board” to the “Main Board” 3) From the “Control Board of Power” to the “Relay,” from the “Relay” to the “Power Board for LED module,” from the “Powe...