ProjectorSupport - ViewSonic Malaysia

There is a pixel stuck on or off

Stuck or twinkling pixels on the projected image may be due to a defective DMD chip. These pixels can show up as bright, dark or twinkling points. They look similar to pixel defects on LCD displays. This cannot be fixed by the end user and must be sent in for service. Contact ViewSonic Customer Care to verify if your unit qualifies for warrant...

The image is out of focus

Make sure that you have set it to its native resolution. Check the user guide to determine what the native resolution of the display is and set it to the native resolution if the video source that is being used can support it. Digital signals (HDMI, DisplayPort) normally produce sharper images. If you are using a VGA or analog signal try to s...

How to adjust the image size on a projector?

Adjust the image size by changing the "Throw Distance," rotating the "Zoom Ring," or using the "Digital Zoom" setting in the menu. Adjust Throw Distance (Physical): This is the most effective method. Move the projector further from the screen for a larger image, and closer for a smaller one. Use the Zoom Ring (Optical): Rotate t...

There is no video when using HDMI port

If you are experiencing problems using HDMI input: Confirm the HDMI input is selected. Plug in the projector first, and then turn on the PC. Replace the HDMI cable, sometimes a cable may go bad. Try another signal type if available for example: VGA, DVI, DisplayPort. Test the projector on a different computer with a HDMI port to make sure...

How to clean the projector lens

To clean the projector lens, do the following: Use a canister of compressed air to remove dust. If the lens is still not clean, use lens-cleaning paper or moisten a soft cloth with lens cleaner and gently wipe the surface. CAUTION: Never rub the lens with abrasive materials

What to do if there is spot on the projected image?

1.If spot is only visible when projected image in defocus, it would not impact usage. 2.If spot is visible when projected image in focus, please contact ViewSonic Service center for help.

Why does my projector turn on and then suddenly shut off?

Automatic shutdown is usually triggered by overheating protection, power-saving settings, or lamp compatibility issues. Check the LED indicator lights for diagnostic clues. Troubleshooting Steps: Check LED Indicators: Temp Light (Red): Indicates overheating. Ensure vents are clear and fans are running. Let the unit cool for 30 minute...

What to do if the projector won't turn on or has no power?

Check all cable connections, verify the LED indicator on the AC adapter, and test a different wall outlet. Verify Connections: Ensure the power cord is firmly seated in the AC adapter "brick" and the plug is fully inserted into the wall outlet. Check Adapter LED: Look for a small light on the adapter unit. LED On: The adapter is re...

How to reset lamp timer

After replacing the Projector Lamp, resetting the lamp timer is highly recommended to help keep track of how long the lamp has been on. The Lamp Timer will also let you know when the lamp needs to be replaced. The Lamp timer can be found in the projector Menu. The specific location of the timer can be found in different locations depending ...

Why is there a high-pitched noise or buzzing from my projector?

Slight humming is often normal for 4K models due to XPR technology. For other noises, check fan settings and power stability. Identify Normal XPR Noise (4K Models): 4K UHD projectors use XPR pixel-shifting technology, which produces a subtle high-pitched hum during operation. This is normal and not a defect. Adjust Fan Settings: Go to ...