Check the monitor: Please do memory recall. Please refer to this FAQ Check device setting: Please check and set to recommended refresh rate. You can refer to this video. https://www.youtube.com/watch?v=sAkbjPiLNcE If possible, please connect monitor to another device with different input. If above doesn’t help, please contact ViewSo...
Please make sure the monitor’s power cable is properly seated in the port and that the monitor is powered on. By default LED indicator will light up when the monitor is powered on. If no LED indicator lights up, please try another power outlet first. If above doesn’t help, please contact ViewSonic service center.
General Precautions Make sure the monitor is turned off and the power cable is unplugged from the power outlet. Never spray or pour any liquid directly onto the screen or case. Doing so could damage your monitor. Dust or hard materials may scratch the screen. Please make sure the cleaning cloth is free of any debris. Clean and dry the m...
Please refer to the video on how to change: https://www.youtube.com/watch?v=sAkbjPiLNcE
If the monitor turns on briefly, then turns off, check the following: Make sure the power cable is securely connected. Turn off the monitor, unplug the power cable for 15 seconds and plug the power cable back then turn on. Check the video cable and make sure it is connected on both ends securely. Reset the factory default ...
Please follow below steps: Open OSD menu: (1) For monitors with [1] and [2] buttons on the front panel, press the number “1” button on the monitor. (2) For monitors with buttons behind the monitor, press the second button from the top. (3) For monitors with a joystick...
The serial number can usually be found on the back or bottom of your product and is either 10 or 12 digits long. The serial number can also be found on the original box of the unit.
These models are optical touch monitors which use two CMOS cameras (optical sensors) placed in the corners at the top of the screen as well as three reflectors (light strips). These cameras are used to look across the entire touch surface for touch events. When an object touches the screen, it blocks some of the light being received by the se...
When using a monitor in the digital (HDMI, DisplayPort) connection, Auto Image Adjust and Manual Image Adjust settings may be disabled. This is normal as the monitor will adjust itself when in the digital mode.
No, as Linux system should automatically identify and recognize the monitor.