1. Press the menu button on the projector or the remote control and then navigate to the Advanced Settings. 2. Select to restore factory default settings. Note: Some models may have the reset option in a slightly different location. Please check the user guide for specific steps.
1.If spot is only visible when projected image in defocus, it would not impact usage. 2.If spot is visible when projected image in focus, please contact ViewSonic Service center for help.
Projectors may shut off for a couple different reasons. If the projector over heats, check to see if there is enough ventilation for air to be circulated around the unit. Make sure fans are running and that there is no obstruction. Let it cool, clear obstructions and check fans when turning the unit back on. After market lamps may cause a...
To locate the maximum or native resolution for a projector, there are a few places this can be found. We highly recommend using the native resolution for LCD displays as this will provide the clearest possible image from the device. Check the product page for your model on the Viewsonic website and you will see the native resolution displaye...
Verify adapter plugged into a wall outlet Make sure the AC adapter is firmly and securely plugged into the wall outlet. Although it may sound obvious, the adapter can become loose without even knowing. If it's not plugged in all the way, it can make it seem like the adapter is not working, but it may just not be getting power from the wall...
The methods for changing the projector lamp (bulb) differ depending on the model of the projector. For accurate instructions, you can find lamp swapping instruction at ViewSonic product download page. <Note> It is recommended that you use an authentic ViewSonic replacement lamp.
When a digital signal is connected (e.g. HDMI, DisplayPort, DVI), there are certain options greyed out in OSD menu as preset settings that cannot be changed. Those greyed out settings will be available when an analog signal (e.g. VGA) is connected.
1. To change the image orientation on the projector, check the projector remote for a button that says “My Button” and press it to change image orientation. This button is customizable but by default it will be set to change the image orientation. 2. Open the projector Menu and go to System Setting: Basic> Projector Position and choose one ...
Or browse to your projector model in the Projector Accessories section of the ViewSonic Store. If a Long Throw lens is available for your projector, it will be listed on the online store. Note: A Long Throw Lens is not available for all ViewSonic projectors. To check availability, or to purchase a long throw lens, please contact ViewSonic...
Stuck or twinkling pixels on the projected image may be due to a defective DMD chip. These pixels can show up as bright, dark or twinkling points. They look similar to pixel defects on LCD displays. This cannot be fixed by the end user and must be sent in for service. Contact ViewSonic Customer Care to verify if your unit qualifies for warrant...