Power Receptacle Type L5-30P, EU, UK, AU, CN (may vary depending on region. double check power supply compatibility) Power Input Voltage Range 100-240 V ~ 50/60Hz Input Current 30A max @110V; 15A max@220V Leakage Current <0.25mA@240VAC Power Outlet quantity 1 (for 108", 135", 163"), 2 (for 216") *Recommended use on a singl...
Answer: The Customer Maintenance Notice is a document that should be explained to the customer on-site, immediately after dvLED installation (during or after software setup). The document contains crucial information regarding proper usage and maintenance critical to effectively extending the life cycle of the product. Note: Full documen...
Please refer to this link before beginning any Direct View LED Display installs. Solution Step 1: Install the Wall-mount brackets Step 2: Install the Cabinets onto the Floor Stand, connect the System Control Box to the Cabinets Step 3: Install the System Control Box onto the Floor Stand Step 4: Install the LED Modules onto t...
Answer: The Receiving Card (aka Receiving Board) plays a part in supplementing LED Module signal connection. It is directly connected to the Transfer Board as shown in Diagram 1 below. Diagram 1: Receiving Card mounted onto Transfer Card Signal is taken from the Transfer Board and sent to the Receiving Card, thus distributing th...
Solution When the display is operating, the current is transmitted in three ways: 1) From the “Power Board for Audio Board” to the “Audio Board” 2) From the “Power Board for Main Board” to the “Main Board” 3) From the “Control Board of Power” to the “Relay,” from the “Relay” to the “Power Board for LED module,” from the “Powe...
Answer: No. There is no trolley option offered at this time. The current available trolley options are for the 108", 135", 163" DVLED sizes.
Answer: "Hard calibration" is a form of hardware calibration that fine tunes the color and brightness for specific LED modules on the DVLED Display. Situations in which hard calibration may be required: LED Module position is changed or LED Module is replaced with a spare, LED Modules from a different color batch need to be used, LED M...
Solution The signal will be sent from the “Main Board” and transmitted in three ways: 1) The first path is from the “Audio Board” to the “Speaker” 2) The second path is to the “RS232 Module” 3) The third path is from the “Transfer Board” to the “Receiving Board,” and from the “Receiving Board” to the “LED Module.” ...
Answer: Chip-on-Board or "COB" refers to the mounting of a bare LED chip in direct contact with a substrate, to produce LED arrays. Differences between SMD LED and COB LED consists of: SMD COB Horizontal Chip Flip Chip has LED PCB does NOT have LED PCB (smaller chip) has gold wires does NOT have gold wires (less blockage of light)...
Answer: Generally speaking, low-end LED displays do not have a power protection mechanism and are more susceptible to damage. Users should avoid repeatedly turning on/off the power to avoid damaging the display for all models.