Please go to Projector Distance Calculator. Enter the desired distance from the screen to calculate the image dimensions. Try different distance values until you find the desired image size.
The projector's image size is determined by the distance between the projector itself and the screen. You can adjust the screen size by repositioning the projector, the image size and the distance needed will be shown in the projector user's manual. Some projectors also come with a zoom ring for the finer adjustment.
1. To change the image orientation on the projector, check the projector remote for a button that says “My Button” and press it to change image orientation. This button is customizable but by default it will be set to change the image orientation. 2. Open the projector Menu and go to System Setting: Basic> Projector Position and choose one ...
1. Here are the hardware requirements to play 3D content below. a. 3D ready projector b. 3D Blu-Ray player c. 3D content d. Active 3D glasses 144Hz e. HDMI Premium Certificate cable 2. Here is the playback process below. a. Connect the 3D Blu-Ray player to the 3D capable projector via HDMI cable. b. T...
Make sure the signal cable is securely connected. 2.Try another video input source or cable or device to crosscheck. 3.Check the current resolution and refresh rate set in the graphic card or video source is compatible with the projector. You can refer to refresh rate setting video. How t...
Please connect the projector to a different AC outlet. Connect the projector to another computer/player. In case above crosscheck remains the same result, please contact ViewSonic service center.
1.Wired connection: 1.1 via 3.5mm audio out: If the projector is equipped with a 3.5 mm audio out mini jack, usually it is green and marked as Audio Out. Please connect a 3.5 mm audio cable between speaker and projector for audio output purpose. 1.2 via S/PDIF: If the model is equipped with S/PDIF por...
Please refer to this FAQ: What to do if there is no sound from the monitor’s speakers when connected with PC/laptop?
Stuck or twinkling pixels on the projected image may be due to a defective DMD chip. These pixels can show up as bright, dark or twinkling points. They look similar to pixel defects on LCD displays. This cannot be fixed by the end user and must be sent in for service. Contact ViewSonic Customer Care to verify if your unit qualifies for warrant...
1. Press the menu button on the projector or the remote control and then navigate to the Advanced Settings. 2. Select to restore factory default settings. Note: Some models may have the reset option in a slightly different location. Please check the user guide for specific steps.