How do I connect external speaker(s) to my projector?

1.Wired connection:   1.1 via 3.5mm audio out:       If the projector is equipped with a 3.5 mm audio out mini jack, usually it is  green and marked as          Audio Out. Please connect a 3.5 mm audio cable between speaker and projector for audio output        purpose.     1.2 via S/PDIF:        If the model is equipped with S/PDIF por...

How to mirror an iPad or an iPhone screen to a projector?

There are 2 ways to mirror from iPad, iPhone (4 or later), or iPod Touch (4th Gen or later):   1. Use an Apple original "Lightning Digital AV Adapter" or "USB-C Digital AV Multiport Adapter" to connect your device to a ViewSonic projector. You might encounter no signal if you don’t use APPLE original adapter.   2.If your projector is equipp...

What to do if the image is too dim from the projector?

1.Please increase the Contrast and Brightness in OSD menu.   2.Check the light source level and make sure it’s on Full or Normal.   3.Turn off or reduce environmental luminance where the projector is in use.

Projector turns on initially but then cycles off

Projectors may shut off for a couple different reasons. If the projector over heats, check to see if there is enough ventilation for air to be circulated around the unit. Make sure fans are running and that there is no obstruction. Let it cool, clear obstructions and check fans when turning the unit back on. After market lamps may cause a...

How to solve flickering image on projector?

  Make sure the signal cable is securely connected.           2.Try another video input source or cable or device to crosscheck.           3.Check the current resolution and refresh rate set in the graphic card or video source is            compatible with the projector. You can refer to refresh rate setting video.           How t...

What to do if remote control does not work properly?

  Please do the following check: Make sure there are no obstructions in the way of the IR receiver on the device. Move closer to the receiver (within 23 feet) or change the angle (within 30 degrees) to the receiver. Replace the batteries. Even if lights on the remote control are on, weak batteries may still cause the remote control to oper...

What to do if the image shows keystone effect from the projector?

When you see below situation, please follow below instructions to adjust:   If the projector supports Auto Keystone or Vertical keystone, please try to turn on or manually adjust by referring to user guide. If possible, put the projector on the flat surface and make sure projector lens and screen are in a 90-degree angle.  

Purchased replacement parts

Parts can be purchased from our parts store. Go to https://www.viewsonic.com/parts/

Why are certain options greyed out in OSD menu?

When a digital signal is connected (e.g. HDMI, DisplayPort, DVI), there are certain options greyed out in OSD menu as preset settings that cannot be changed. Those greyed out settings will be available when an analog signal (e.g. VGA) is connected.

How to solve “Out of range” when connecting PC/laptop to a projector?

Please refer to this FAQ.