Choose another country or region to see content specific to your region
USA

How to make the screen fit my projector's display area?

Please refer to this FAQ:   How to solve the overscan problem with my monitor?

How to solve “Out of range” when connecting PC/laptop to a projector?

Please refer to this FAQ.

Projector turns on initially but then cycles off

Projectors may shut off for a couple different reasons. If the projector over heats, check to see if there is enough ventilation for air to be circulated around the unit. Make sure fans are running and that there is no obstruction. Let it cool, clear obstructions and check fans when turning the unit back on. After market lamps may cause a...

What to do if the image is too dim from the projector?

1.Please increase the Contrast and Brightness in OSD menu.   2.Check the light source level and make sure it’s on Full or Normal.   3.Turn off or reduce environmental luminance where the projector is in use.

Why are certain options greyed out in OSD menu?

When a digital signal is connected (e.g. HDMI, DisplayPort, DVI), there are certain options greyed out in OSD menu as preset settings that cannot be changed. Those greyed out settings will be available when an analog signal (e.g. VGA) is connected.

What to do if I can't mirror my screen after I updated the iOS version to iOS14?

Due to iOS14 compatibility issues, please follow below table for solution.   Model Solution X100-4K Install EAirPlay.apk and follow instruction X10-4K Update FW to V1.13 via OTA M2 Update FW to V1.0 via OTA M1+_G2/M1+_V Update FW to V1.04 via OTA M1 mini plus Update FW to V1.02 via OTA SOP URL: https://support.viewsonic.com/hel...

How to reset lamp timer

After replacing the Projector Lamp, resetting the lamp timer is highly recommended to help keep track of how long the lamp has been on. The Lamp Timer will also let you know when the lamp needs to be replaced. The Lamp timer can be found in the projector Menu. The specific location of the timer can be found in different locations depending ...

What to do if there is spot on the projected image?

1.If spot is only visible when projected image in defocus, it would not impact usage.   2.If spot is visible when projected image in focus, please contact ViewSonic Service center for help.

What to do if remote control does not work properly?

  Please do the following check: Make sure there are no obstructions in the way of the IR receiver on the device. Move closer to the receiver (within 23 feet) or change the angle (within 30 degrees) to the receiver. Replace the batteries. Even if lights on the remote control are on, weak batteries may still cause the remote control to oper...

Why a black border on the top/bottom or sides of the image from the projector?

Please check below:   1.Plesae refer to the user guide and adjust Aspect ratio with example below.   2. It could be the format of the movie since not all movies are formatted in 16:9. Some are formatted wider than 16:9 which will create black borders on the top and bottom of the screen.

联系我们

如果您无法获得 ViewSonic 产品相关的解决方案,请直接与我们联系