ViewSonic Commercial Displays do not support antenna or coaxial cable connection.
Here’re major steps to set up video wall in portrait position for your reference. 1. Set up monitor ID in OSD menu as 1~4 prior to mounting monitors. 2. Connect IR sensor cable to monitor 1. 3. Connect the PC to monitor 1 with DP cable firstly for easy setup & adjustment afterwards. 4. Mounting monitor 1/2/3/4 in portrait p...
Download ADB from https://developer.android.com/studio/command-line/adb.html 1. Run cmd commend and go to the adb save folder that connect to device via Adb over TCP, if use Adb wire, skip this step adb connect {ip} for example: adb connect 192.168.2.112 2. Take screen shot and save to device adb shell screencap -p /sdcard...
You can refer below steps to check the issue. 1. To reset the NMP-302w. 2. To replace the HDMI(extension) cable. If above steps can't solve the issue, it will be NMP-302w mainboard issue, you need to replace NMP-302w.
1. Is it correct of RS232 daisy chain cable ? 2. In OSD menu, General settings -> Eco mode please set to Normal. (If set to Low power standby, the unit can power OFF but can’t power ON) 3. The RS232 daisy chain cable is 2.4mm – 2.4mm
Upgrade under the factory menu Copy MstarUpgrade.bin in USB and Insert U disk to the USB port Press Input menu and then press 2 5 8 0 to activate factory menu (Fig. 1) Move to “Upgrade Main” item and press OK button to confirm. (Fig. 2) Select “Confirm” to confirm the upgrade (Fig. 3), the system will automatically reboot and start the up...
Support HDMI Ver. 1.4b DVI cable can't exceed 5M, otherwise, a DVI extender is required HDMI cable can't exceed 5M, otherwise, a HDMI extender is required LAN Cable can't be used to carry video signal directly Signal cable for each display should be separated from each other, twists cables together is not allowed Device for signal transmi...
Please follow below steps: Click Start and then Control Panel, and next Hardware and Sound. Under Tablet PC Settings, tap Calibrate the screen for pen or touch input. On the Display tab, under Display options, tap Calibrate and then Yes to allow the program to make changes. 4.Select the Touch input option. ...
You can click "Help"-->"Check update" in Tool bar to check is your Signage Manager newest or not, if not, you can click "Download" to update your Signage Manager.
EP5520T uses IR touch module, the sunlight will cause IR touch module abnormal, please place your EP5520T far away from sunlight.