Please refer to user guide on page "Important Safety Instructions". Some projectors may be claimed to use at a limited angle dependent on the light source, such as lamp or LED.
Usually this is related to unmatched output resolution setting and content. For example, setting 720P resolution output to a 4K projector or playing a 720P video on a 4K projector in full screen would cause pixelated. Please make sure to set recommended resolution by referring to this FAQ.
Stuck or twinkling pixels on the projected image may be due to a defective DMD chip. These pixels can show up as bright, dark or twinkling points. They look similar to pixel defects on LCD displays. This cannot be fixed by the end user and must be sent in for service. Contact ViewSonic Customer Care to verify if your unit qualifies for warrant...
Please do the following check: Make sure there are no obstructions in the way of the IR receiver on the device. Move closer to the receiver (within 23 feet) or change the angle (within 30 degrees) to the receiver. Replace the batteries. Even if lights on the remote control are on, weak batteries may still cause the remote control to oper...
1.If spot is only visible when projected image in defocus, it would not impact usage. 2.If spot is visible when projected image in focus, please contact ViewSonic Service center for help.
After replacing the Projector Lamp, resetting the lamp timer is highly recommended to help keep track of how long the lamp has been on. The Lamp Timer will also let you know when the lamp needs to be replaced. The Lamp timer can be found in the projector Menu. The specific location of the timer can be found in different locations depending ...
Please check below: 1.Plesae refer to the user guide and adjust Aspect ratio with example below. 2. It could be the format of the movie since not all movies are formatted in 16:9. Some are formatted wider than 16:9 which will create black borders on the top and bottom of the screen.
Before connecting two projectors to your Windows PC/laptop, please ensure your system can run multiple video outputs. 1. To check your graphics card's maximum number of output signals, please refer to the graphics card manufacturer like the example below. Dedicate Graphics Card Integrate Graphics Card 2. Make sure your devi...
Please refer to this FAQ: How to solve the overscan problem with my monitor?
If a fan begins to make a rumbling noise this may indicate a problem with the fan. Fans are essential to maintain optimal operating efficiency of the projector; so it is strongly recommended that the unit be sent in for service to replace the fan. If it seems like there is something hitting the fan blades it could mean that there is an obstru...