How to play 3D content from Blu-Ray player to projectors?

1. Here are the hardware requirements to play 3D content below.     a. 3D ready projector     b. 3D Blu-Ray player     c. 3D content     d. Active 3D glasses 144Hz     e. HDMI Premium Certificate cable   2. Here is the playback process below.       a. Connect the 3D Blu-Ray player to the 3D capable projector via HDMI cable.       b. T...

How to make the screen fit my projector's display area?

Please refer to this FAQ:   How to solve the overscan problem with my monitor?

How to mirror an iPad or an iPhone screen to a projector?

There are 2 ways to mirror from iPad, iPhone (4 or later), or iPod Touch (4th Gen or later):   1. Use an Apple original "Lightning Digital AV Adapter" or "USB-C Digital AV Multiport Adapter" to connect your device to a ViewSonic projector. You might encounter no signal if you don’t use APPLE original adapter.   2.If your projector is equipp...

The projector fan stays on after the unit has been turned off

On some projector models, the fan will remain on after the unit has been shut down and in standby mode. This is normal operation for any model with the network feature that had been enabled. The feature can be disabled by selecting Menu>Option>Network > Off. If the Network feature is enabled then expect the fan to remain on at a lower speed w...

Where can I find ViewSonic projector distance calculator?

Please go to Projector Distance Calculator. Enter the desired distance from the screen to calculate the image dimensions. Try different distance values until you find the desired image size.

How do I connect external speaker(s) to my projector?

1.Wired connection:   1.1 via 3.5mm audio out:       If the projector is equipped with a 3.5 mm audio out mini jack, usually it is  green and marked as          Audio Out. Please connect a 3.5 mm audio cable between speaker and projector for audio output        purpose.     1.2 via S/PDIF:        If the model is equipped with S/PDIF por...

What to do if remote control does not work properly?

  Please do the following check: Make sure there are no obstructions in the way of the IR receiver on the device. Move closer to the receiver (within 23 feet) or change the angle (within 30 degrees) to the receiver. Replace the batteries. Even if lights on the remote control are on, weak batteries may still cause the remote control to oper...

What to do if the image is too dim from the projector?

1.Please increase the Contrast and Brightness in OSD menu.   2.Check the light source level and make sure it’s on Full or Normal.   3.Turn off or reduce environmental luminance where the projector is in use.

How to set up dual projectors on a Windows computer?

Before connecting two projectors to your Windows PC/laptop, please ensure your system can run multiple video outputs. 1. To check your graphics card's maximum number of output signals, please refer to the graphics card manufacturer like the example below. Dedicate Graphics Card Integrate Graphics Card  2. Make sure your devi...

How to restore the default settings on a projector?

1. Press the menu button on the projector or the remote control and then navigate to the Advanced Settings.   2. Select to restore factory default settings.   Note: Some models may have the reset option in a slightly different location. Please check the user guide for specific steps.